Panasonic KX-NT400

Note
The IP addresses of PBXs cannot be obtained from
the DHCP server. You must manually enter the PBX
IP addresses.
PBX IP Address 1
Enter the IP address of the primary PBX. Press
Test to verify the connection to the PBX.
PBX IP Address 2
If your network uses a secondary PBX, enter the IP
address of the secondary PBX. Press Test to verify
the connection to the PBX.
PBX Change Time
If your network uses a secondary PBX, enter the
length of the time before the failover process starts.
• Default: 60 seconds
Note
• You can confirm the connection to the
secondary PBX after programming. When the
KX-NT400 is starting up, press and hold both
(HOLD) and until the message "Now
starting ..." appears.
To reconnect to the primary PBX, restart the
KX-NT400. For details, see "Restarting the
KX-NT400 (Page 168)".
• You can also use the dial keys to enter the IP
addresses. See "Entering Characters
(Page 145)".
• You can reset the settings to their default values
by pressing Reset to Default.
IP Port Settings
To properly connect the KX-NT400 to a network, the IP
port settings must be configured to match the settings
of the network. Consult your administrator for details
about the correct settings.
If your network uses a secondary PBX, also fill in the
following for IP Port 2:
• PTAP Server
• PTAP Client
Note
• These settings should be configured only by an
administrator or installation personnel. An
access code is required to access these
screens.
IP Port Setting screen (1/2)
Enter the IP ports of the PTAP server and PTAP client
for IP Port 1 that the KX-NT400 will use to communicate
over the network.
PTAP Server
Enter the port number for the PTAP server.
• Default: 9300
PTAP Client
Enter the port number for the KX-NT400 to use for
PTAP communication.
• Default: 9301
IP Port Setting screen (2/2)
If your network uses a secondary PBX, enter the IP
ports of the PTAP server and PTAP client for IP Port
160 Operating Instructions Document Version 2010-01
Installation and Settings