2.6 Utility
66 PC Programming Manual
To perform a card test
1.
From the Utility menu, select Diagnosis.
2. Click on the Status cell of the card to be tested, and set it to "OUS".
With the KX-TDA30, to perform the EXT-CID path test, set the status of both the EXT-CID card
and the card in slot 1 to "OUS".
3. Click on the cell showing the card type.
A new window will be displayed.
4. Select the Card Test option.
A new window will be displayed.
5. Click Test to perform the test(s).
The error report will be displayed. When all tests are completed, the words "Test End!" will be
shown on the last line of the output.
6. Select an option:
•Click Capture if you want to save the displayed information.
1. Enter a file name, or select a file to overwrite.
2. Click Save.
•Click Cancel to return to the Diagnosis screen.
Pair Port Test (KX-TDA100/KX-TDA200/KX-TDA600 only)
Tests the combination of an extension port and trunk port to ensure that communication with the trunk
port can be carried out successfully.
IP-GW H.323 call simulate
diagnosis
LAN loop back diagnosis
KX-TDA100/KX-TDA200/KX-TDA600
DHLC
DLC
SLC8
SLC16/MSLC16/ESLC16/EMSLC16/CSLC16/ECSLC24
CSIF
LCOT/ELCOT
T1
E1
BRI
PRI
OPB
E&M
CTI-LINK
DID
IP-GW4 (TDA0484)
IP-GW16
IP-EXT16
To Next Page
Loading...
