Panasonic KX-TDA100

2.6 Utility
PC Programming Manual 67
The pair port test can be carried out using one LCOT or ELCOT card and one DHLC, SLC8, SLC16,
MSLC16, ESLC16, EMSLC16, CSLC16, or ECSLC24 card.
Note
With the KX-TDA600, the pair of cards to be used for the pair port tests must be installed within
the same shelf.
The tests that are performed are as follows:
To perform a pair port test
1.
From the Utility menu, select Diagnosis.
2. Click on the Status cell of the extension card to be tested, and set it to "OUS".
3. Click on the cell showing the card type.
A new window will be displayed.
4. Select the Pair Port Test option.
A new window will be displayed. The card you selected in Step 3 will be shown in the Extension
Line Slot No. drop-down list.
5. From the CO Line Slot No. drop-down list, select the slot number of the trunk card you want to
test.
6. From the CO Line Port No. drop-down list, select the port number of the trunk you want to test.
7. Click Test.
The error report will be displayed.
8. Select an option:
•Click Capture if you want to save the displayed information.
1. Enter a file name, or select a file to overwrite.
2. Click Save.
•Click Cancel to return to the Diagnosis screen.
Network Loopback Test (KX-TDA100/KX-TDA200/KX-TDA600 only)
Performs a remote loopback test on the PRI23 card.
Notes
• To perform this test, it is necessary to set Loopback Test started by Network in 2.8.16 [1-
1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only) to
"Enable".
• The version of the PRI23 card must be 2.000 or later.
Line current OFF (Ext—>CO) Line current from extension to trunk turns off.
Line current ON (Ext—>CO) Line current from extension to trunk turns on.
Off hook detection (CO—>Ext) Off-hook generation/detection from trunk to extension
DTMF detection (CO—>Ext) DTMF generation/detection from trunk to extension
DP detection (CO—>Ext) DP generation/detection from trunk to extension
BELL detection (Ext—>CO) BELL generation/detection from extension to trunk
Speech path (Ext—>CO) Speech path from extension to trunk
Speech path (CO—>Ext) Speech path from trunk to extension