Panasonic KX-TDA100 - Page 820

3.2 Feature Programming References
820 PC Programming Manual
– CPC Signal Detection (DDI/DID)—Outgoing, Incoming
– CPC Signal Detection (LCO/GCO)—Outgoing, Incoming
• 2.8.25 [1-1] Slot—Port Property - E1 Port—CPC Detection Time—Out, In
• 2.8.31 [1-1] Slot—Port Property - DID Port—CPC Detection Time—Out (DID), In (DID)
Feature Guide Reference
1.11.10 Calling Party Control (CPC) Signal Detection
Calling/Connected Line Identification Presentation (CLIP/COLP)
• 2.8.14 [1-1] Slot—Port Property - BRI Port
– ISDN CO—Subscriber Number
– Supplementary Service—COLP, CLIR, COLR, CNIP, CONP, CNIR, CONR, CF
(Rerouting), CT, CCBS, AOC-D, AOC-E, 3PTY
• 2.8.16 [1-1] Slot—Port Property - PRI Port (KX-TDA100/KX-TDA200/KX-TDA600 only)
– CO Setting—Subscriber Number
– Supplementary Service—COLP, CLIR, COLR, CNIP, CONP, CNIR, CONR, CF
(Rerouting), CT, CCBS, AOC-D, AOC-E, 3PTY
• 2.8.19 [1-1] Slot—Port Property - T1 Port (KX-TDA100/KX-TDA200/KX-TDA600 only)—
Subscriber Number
• 2.8.25 [1-1] Slot—Port Property - E1 Port—Subscriber Number
• 2.9.8 [2-6-1] Numbering Plan—Main—Features
– COLR Set / Cancel
– CLIR Set / Cancel
– Switch CLIP of CO Line / Extension
• 2.9.17 [2-9] System Options—Option 4—Send CLIP of CO Caller to ISDN—when Transfer
(CLIP of Held Party)
• 2.10.13 [3-5-1] Incoming Call Distribution Group—Group Settings—Main—CLIP on ICD
Group Button
• 2.11.1 [4-1-1] Wired Extension—Extension Settings
– Main—Extension Number
– Option 1—CLIP ID
– Option 3—CLIP on Extension/CO
– Option 3—CLIR
– Option 3—COLR
• 2.11.5 [4-1-4] Wired Extension—Flexible Button—Type
• 2.11.10 [4-2-1] Portable Station—Extension Settings
– Option 1—CLIP ID
– Option 3—CLIP on Extension/CO
– Option 3—CLIR
– Option 3—COLR
• 2.11.13 [4-2-3] Portable Station—Flexible Button—Type
• 2.11.17 [4-3] DSS Console—Type
Feature Guide Reference
1.21.1.2 Calling/Connected Line Identification Presentation (CLIP/COLP)