To Next PageTo Next Page
How to resolve LPR start up error on my Panasonic KX-TDA100 PBX?
If your Panasonic PBX displays an "LPR start up error (ROM NG)", pull out and re-insert the corresponding optional service card (DHLC, DLC, CSIF, T1, E1, BRI, PRI, OPB3, CTI- LINK, E&M, IP-GW). You can also try pressing the Reset Button or replacing the card.
How to fix 'Over Card Limitation' error on my Panasonic KX-TDA100?
To resolve an "Over Card Limitation" error on your Panasonic PBX, reduce the number of optional service cards installed.
How to fix 'PT connection over' error on my Panasonic KX-TDA100 PBX?
To resolve a "PT connection over" error on your Panasonic PBX, reduce the number of connected PTs (Proprietary Telephones).
What to do if my Panasonic KX-TDA100 PBX says 'No Service'?
If you see 'No Service' on your Panasonic PBX handset, it could be due to two reasons. Either the handset is out of range, in which case you should move closer to the base unit, or the base unit is turned off. Ensure the power cord is properly connected to the base unit.
What does 'Charge Battery' mean on my Panasonic KX-TDA100 PBX?
If your Panasonic PBX handset displays 'Charge Battery', it means the battery has little charge remaining. You should fully charge the battery.
Why is there so much noise on my Panasonic PBX calls?
If you are frequently hearing noise when using your Panasonic PBX, try setting the handset and base unit away from other electrical appliances. Also, move closer to the base unit to improve the signal.
How to fix a Panasonic KX-TDA100 PBX handset that won't turn on?
If your Panasonic PBX handset does not work, there are several possible causes: * The battery may be drained: Charge the battery fully. * The power is OFF: Turn it ON. * If none of the above help, re-insert the battery and try again.
What to do if my Panasonic PBX says 'Memory Full'?
If your Panasonic PBX displays 'Memory Full', it means the phonebook is full and cannot store new items. To resolve this, remove unnecessary data from the phonebook and try again.
Why can't I make calls on my Panasonic PBX?
If you cannot make or receive calls on your Panasonic PBX, it might be because the handset is out of range. Try moving closer to the base unit. Also, check the telephone line to ensure it is properly connected.
Why is the charge indicator flashing red on my Panasonic PBX?
If the charge indicator on your Panasonic PBX flashes red rapidly, it could be due to the charger not being connected properly. Make sure the battery is inserted properly and set the handset in the charger correctly.
General| System Capacity | Up to 128 extensions |
|---|---|
| VoIP Support | Yes, with optional cards |
| Digital Extensions | Yes |
| Analog Extensions | Yes |
| ISDN Support | Yes |
| Power Supply | AC 100-240 V, 50/60 Hz |
| Operating Temperature | 0°C to 40°C |
| Humidity | 10% to 90% (non-condensing) |
| Networking | Yes |
| Type | Hybrid IP PBX |
| Wireless Capability | Yes |
| Supported Extensions | Digital, Analog |
| Trunk Interfaces | Analog, ISDN |
| Voicemail Capacity | Optional, via voice processing cards |
