2.7 [1] Configuration
164 PC Programming Manual
Programming Manual References
None
Feature Manual References
None
First Dial Timer (CO)
Specifies the minimum time that the PBX waits after seizing a CO line, before sending the dialed digits
to the telephone company. This allows the telephone company to have enough time to accept the
dialed digits correctly.
Default
1.0 s
Value Range
0.5 × n (n=1–16) s
Maintenance Console Location
2.7.16 [1-1] Slot—T1 Card Property (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
Feature Manual References
None
First Dial Timer (DID/TIE)
Specifies the minimum time that the PBX waits after seizing a DID or TIE line, before sending the
dialed digits to the telephone company or to another PBX. This allows the telephone company or the
other PBX to have enough time to accept the dialed digits correctly.
Default
64 ms
Value Range
32 × n (n=1–255) ms
Maintenance Console Location
2.7.16 [1-1] Slot—T1 Card Property (KX-TDA100/KX-TDA200/KX-TDA600 only)
Programming Manual References
None
Feature Manual References
None
To Next Page
Loading...
