Panasonic KX-UT113 - Statistical Information; RTCP Enable; RTCP Interval; Jitter Buffer

Configuration File Reference DSCP_RTCP_n (Page 226)
4.5.4.2 Statistical Information
RTCP Enable
Description Selects whether to enable or disable RTCP (Real-Time Transport
Control Protocol). For details, refer to RFC 3550.
Value Range
• Yes
• No
Default Value No
Configuration File Reference RTCP_ENABLE_n (Page 229)
RTCP Interval
Description Specifies the interval, in seconds, between RTCP packets.
Value Range 5–65535
Default Value 5
Configuration File Reference RTCP_INTVL_n (Page 227)
4.5.4.3 Jitter Buffer
Maximum Delay
Description Specifies the maximum delay, in 10-millisecond units, of the jitter buffer.
Value Range
3–50 (´ 10 ms)
Note
• This setting is subject to the following conditions:
– This value must be greater than [Initial Delay]
– This value must be greater than [Minimum Delay]
– [Initial Delay] must be greater than or equal to [Minimum
Delay]
Default Value
20 (´ 10 ms)
Configuration File Reference MAX_DELAY_n (Page 227)
Minimum Delay
Description Specifies the minimum delay, in 10-millisecond
units, of the jitter buffer.
Document Version 2012-02 Administrator Guide 115
4.5.4 VoIP Settings [Line 1]–[Line x]