10. Using Menu Functions
188
Set whether to give priority to focus or shutter release during Auto Focus.
• Different settings can be applied to different Focus Mode settings ([AFS/AFF], [AFC]).
Focus positions are stored separately for the camera's horizontal and vertical orientations.
When setting the AF area position or the MF Assist display position, you can now loop the
position from one edge to the other edge of the screen.
This changes the AF area display setting for when the Auto Focus Mode is set to [ ]
([49-Area]) or [ ], etc. ([Custom Multi]).
[Focus/Release Priority]
[FOCUS] Disables recording when focus is not achieved.
[BALANCE]
Performs recording while controlling the balance between focusing and
shutter release timing.
[RELEASE] Enables recording even when focus is not achieved.
[Focus Switching for Vert / Hor]
[ON]
Memorises separate positions for horizontal
and vertical orientations (two vertical
orientations, left and right, are available).
• The following last-specified positions will be
memorised.
– The last AF area position (when [ ], [Ø] or [ ] is used)
– The last MF Assist display position
[OFF] Sets the same setting for both horizontal and vertical orientations.
[Loop Movement Focus Frame]
[AF Area Display]
[ON]
Displays AF areas on the recording screen.
• AF areas are not displayed when the default AF area setting is applied to
[ ] ([49-Area]) or [ ], [ ] or [ ] in [Custom Multi].
[OFF]
Displays AF areas on the recording screen for just a few seconds after you
start using them.
• Even when [ON] is set, the same operation as [OFF] is performed in the following cases:
– When recording motion pictures
– When recording 4K photos
ヤヒ ヤビ
To Next Page
Loading...
Need help?
General
