Panasonic MINAS A6 Multi Series - 5.2.12 Friction Torque Compensation

Auto Tuning Functions
5-52
5.2.12 Friction torque compensation
To reduce effect of friction represented by mechanical system, 3 types of friction torque compensation
can be applied:
 Offset load compensation that cancels constant offset torque
 The dynamic friction compensation that varies direction as the operating direction varies
 Viscous friction torque correction amount that is varied by the command speed
Applicable range
This function can be applicable only when the following conditions are satisfied.
Conditions under which the Friction torque compensation is activated:
Control Mode
 Specific to individual functions. Refer to “Relevant parameters” shown below.
Others
 Should be in servo-on condition
 Parameters except for controls such as torque limit setup, are correctly set, assuring that the motor can run smoothly.
Relevant parameters
Combine the following 3 parameters to setup appropriate friction torque compensation.
 Relevant parameters
Class
No.
Attribute
Title
Range
Unit
Function
6
07
B
Torque command
additional value
-100 to
100
%
Set up the offset load compensation value usually added
to the torque command in a control mode except for the
torque control mode.
6
08
B
Positive direction
torque
compensation
value
-100 to
100
%
Dynamic friction compensation value to be added to the
torque command at the time of position control and
full-closed control and when forward direction position
command is entered.
6
09
B
Negative direction
torque
compensation
value
-100 to
100
%
Dynamic friction compensation value to be added to the
torque command at the time of position control and
full-closed control and when reverse direction position
command is entered.
6
50
B
Viscous friction
compensating
gain
0 to
10000
0.1%
(10000r/min)
When Two-degree-of-freedom control mode is effective,
the result multiplying the command speed by this setting
is added to the torque command as the viscous friction
torque correction amount. By setting the estimated
viscous friction coefficient of Real-time auto tuning, there
are cases in which the feedback scale position deviation
in the vicinity of steady state may be improved.