Panasonic MINAS A6 Multi Series - 11.1 Basic Specifications (Power Supply Module)

Power Supply Module
11-2
11.1 Basic specifications
The specifications of the power supply module (PSM) are shown below.
For hardware specifications, refer to "REFERENCE SPECIFICATIONS Power supply module section
(SX-DSV03452)".
Item
Content
Main power supply
3-phase, 400 V
Control power supply
DC 24 V
Control input signal
DIN1
Contactor feedback
DIN2
Regenerative resistor monitoring
Control output signal
1 power relay output for contactor control
Front panel
2 LEDs
RDY (green)
State in which power supply is possible
ERR (red)
State with power supply module alarm/warning detection
Regenerative function
Excess regenerative power can be consumed by installing a regenerative resistor
outside the power supply module.
Protective
functions
Control power supply monitoring
Undervoltage
Main power supply monitoring
Overvoltage
Phase lack,
Overcurrent,
Undervoltage (Note 1)
AC interruption (Note 1)
Regenerative monitoring
Overload,
Rgenerative resistance temperature monitoring
Temperature monitoring
Heatsink overheating,
Amospheric overheating
Contactor monitoring
Contactor feedback error
Self-diagnosis
Regenerative drive Tr/IC error
Thermistor failure
CPU error
Watchdog, etc.
(Note 1) These two main power monitoring results are not detected on the power supply module side, but the monitoring results are
notified to all connected driver modules, and combined with the conditions on the driver module side, Err13.0 / An alarm is
detected as Err13.1.