Chapter 3 Basic Operations — Turning on/off the projector
50 - ENGLISH
Turning off the projector
1)
1)
2)
1) Press the power <v/b> button.
f The [POWER OFF(STANDBY)] conrmation screen is displayed.
2) Press qw on the remote control to select [OK], and press the <ENTER> button.
(Or press the power <v/b> button again.)
f The projection is nished.
3) Wait for a few seconds until the power indicator <ON (G)/STANDBY (R)> lights in red.
4) Turn off the power of the track system if necessary.
Note
f Even when the power is turned off by pressing the power <v/b> button, the projector consumes power if the power of the track
system is turned on.
The power consumption during standby can be conserved when the [SETUP] menu → [ECO MANAGEMENT]→ [STANDBY MODE] is set
to [ECO].
f The projector can be turned off by turning off the power of the track system during the projection, but the settings and adjustments
performed right before turning off the power may not be reected.
f Do not turn off the power of the track system or eject the SD card while the SD card indicator <SD> is blinking. The projector may not
operate properly or the contents of the SD card may get damaged.
f When the [SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] is set to [NORMAL], the internal cooling fan may operate even
during standby.
To Next Page
Loading...
