Chapter 5 Operations — Network connection
ENGLISH - 109
Note
f A LAN cable is required to use the network function via wired LAN.
f Use a straight or crossover LAN cable that is compatible with category 5 or higher. Whether either of straight/crossover cable or both cables
can be used differ depending on the system conguration. Consult your network administrator. The projector recognizes the cable type
(straight/crossover) automatically.
f Use a LAN cable of 100 m (328'1") or shorter.
Setting for projector
1) Connect the projector and a computer using a LAN cable.
2) Turn on the projector.
3) Press the <MENU> button to open the [NETWORK] menu and configure settings for [WIRED LAN].
f Refer to [WIRED LAN] (x page 82) for details.
Note
f Consult your network administrator before connecting to an existing network.
f The following settings are congured as the factory defaults.
[DHCP]
OFF
[IP ADDRESS]
192.168.10.100
[SUBNET MASK]
255.255.255.0
[DEFAULT GATEWAY]
192.168.10.1
[DNS1]/[DNS2]
None
Setting for computer
1) Turn on the computer.
2) Configure network settings following the instructions of your network administrator.
f If the projector is in the factory default settings, congure the network settings of the computer as follows,
and then you can use network functions.
[IP ADDRESS]
192.168.10.101
[SUBNET MASK]
255.255.255.0
[DEFAULT GATEWAY]
192.168.10.1
When connecting via wireless LAN
Connection example
IEEE802.11a/b/g/n
ABC
To Next Page
Loading...
