9.5.6. USB Error Code Table
Error
Code
F650 USB device: Devices Devices other than the mass storage Press [ STOP] on
other than mass class are connected. main unit for next error.
storage
F651 USB device: Non- The device that the transfer rate did not Press [ STOP] on
Full Speed Device correspond to Full Speed was main unit for next error.
connected.
F652 USB device: The device in the interface (subclass) Press [ STOP] on
Interface NG outside correspondence was main unit for next error.
connected. (correspondence interface)
001b: Reduced Block Commands
(RBC)
010b: SFF-8020i. MMC-2 (ATAPI)
110b: SCSI transparent command set.
F655 USB device: The overcurrent of 500mA or more was Press [ STOP] on
Overcurrent detected in VDD USB, and the USB main unit for next error.
detection device driver function was intercepted.
(To intercept the current.)
Diagnosis Contents Description of error Automatic FL Display Remarks
9.6. Sales Demonstration Lock Function
This function prevents discs from being lost when the unit is used for sales demonstrations by disabling the disc eject function.
"LOCKED" is displayed on the unit, and ordinary operation is disabled.
9.6.1. Setting
·
Prohibiting removal of disc
1. Select the DVD/CD function.
2. At POWER ON condition, press and hold down the
button and the power button on the player for at least three
seconds. (The message, “___LOCKED_” appears when the function is activated.)
Note:
OPEN/CLOSE
and DISC EXCHANGE buttons are invalid and the player displays “___LOCKED_” while the lock
function mode is entered.
·
Prohibiting operation of selector and disc
1. Select the DVD/CD function.
2. At POWER ON condition, press and hold down the
button and the power button on the player for at least three
seconds. (The message, “___LOCKED_” appears when the function is activated.)
Note:
The following buttons are invalid and the player displays “___LOCKED_” while the lock function mode is entered.
Player , , SELECTOR, /, , / , DISC EXCHANGE, DISC SKIP, DISC1-DISC5
Remote
controller unit
NUMERIC KEYS 0~9, , , , , , , , FUNCTIONS, REPEAT, SLEEP,
TOP MENU, RETURN, FL DISPLAY, SETUP, CH SELECT, QUICK OSD, DISC, SELECT, MUTING, MENU & 2ND
SELECT
9.6.2. Cancellation
The lock can be cancelled by the same procedure as used in setting. ("UNLOCKED" is displayed on cancellation. Disconnecting
the power cable from power outlet does not cancel the lock.)
50
SA-PT750P / SA-PT750PC
To Next Page
Loading...
