DA7 Users’ Guide
3
-
1
3
Quick Start
As with any mixer, the basics come first. Take it out of the box, plug it into a
standard three-prong, 120v 60Hz electrical outlet, and turn it on. Once the
novelty has passed of seeing all the colored lights and the faders going up
and down when the buttons are pressed, your real fun can begin.
There are several basic functions that, once you become familiar with, will
make the DA7 easy to use. This Quick Start Guide assumes that you have a
basic knowledge of audio technology.
Chapter 3
Quick Start
If you have already started pushing buttons, press the Fader
Layer INPUT 1-16 LED button, turn off all the channels, and
lower all the faders. Then, press the CHANNEL button to display
the [CHANNEL] window. Or, if you wish to start fresh, reset the
DA7 back to the factory presets by turning the unit off. Then hold
down both the METER and CHANNEL buttons in the MASTER
DISPLAY area. While holding these buttons down, turn the DA7
back on. Your mixer will restart automatically.
The “reset to default” procedure, in the tip above, will reset all
the mixer functions and clear all the library and memory registers.
This is an irrevocable procedure. You can protect your data by
copying it to a backup using the [MIDI>BULK] procedure
described in Section 11-4.
To Next Page
Loading...
