Parker NitroFlow HP - Electricity; Safety Precautions

K3.1.141e Manual NitroFlow HP_EN.doc - 10 -
• The NitroFlow
®
HP is not designed for installation in an Ex-
classified area.
• Do not install the NitroFlow
®
HP in an area where explosive
mixtures may occur.
2.3 Electricity
Warning
• Only service-engineers, qualified to work on electric equipment,
are allowed to do the installation, maintenance and repairs.
• Disconnect the main power supply before you do maintenance or
repair.
• If a service-engineer has to work on the NitroFlow
®
HP while the
electric power is connected, the service-engineer must be very
careful with respect to the electrical hazards.
2.4 Safety precautions
Warning
• Make sure that the ventilation rate is sufficient in the room where
the enriched oxygen is ventilated, or vent the enriched air outside.
• Only feed the NitroFlow
®
HP with air.
• Keep the air feed to the NitroFlow
®
HP clean and free of organic
solvent vapors and other contaminants. Do not place the
NitroFlow
®
HP in a room where organic solvent vapors may occur
in the air.
• Keep the ambient temperature for the NitroFlow
®
HP range
between 10°C and 40°C (50°F and 104°F).
• Adjust the NitroFlow
®
HP to the appropriate nitrogen
concentration for your application.
• Install the peripheral equipment, piping and nitrogen storage
vessels according to standard procedures. Parker Filtration &
Separation B.V. cannot take responsibility for this.
• Do regular maintenance to the NitroFlow
®
HP, to ensure proper
and safe operation. Refer to chapter 9.
• Make sure that instructions concerning health and safety are
compliant with the local legislation and regulations.