Parker NitroFlow HP - Software Updates

K3.1.141e Manual NitroFlow HP_EN.doc - 42 -
Button Explanation
A Status of the alarm (new, reset, accepted) and information when
machine turned on by power)
B Date and time that the alarm occurred
C The description of the alarm that occurred
D The code of logged (saved) alarm
Each month a log file is saved in a folder on the SD-card (maximum 12 files, after
that the oldest file will be overwritten). It is possible to read the logged data from the
SD-card on a computer. Extra software (NitroView) has to be installed on your
computer for this option (contact your supplier for this software). Your PC also needs
a SD-card reader.
1. Switch off the generator
2. Remove the SD-card (refer to §3.3)
3. Refer to appendix A for information how to use the NitroView software.
4. Replace the SD-card in the generator
5. Switch on the nitrogen generator
WARNING:
The unit cannot run without the SD-card. This will generate an alarm
(SD-card failed)
6.3 Software updates
The software version for the touch screen controller for the NitroFlow
®
HP can be
found in the maintenance
-menu (refer to §6.2.8). When Parker Filtration &
Separation updates the software, a new version can be put on the touch screen
controller following the instructions in appendix B of this manual.
Caution:
Please check the alarm, P-switch, options and settings before
restarting the unit.