Parker Sporlan S3C - Viewing Case Control Firmware Revision; Firmware Updates

Bulletin 100-50-9.1 – Page 133
4. Remove valve module either by pressing down and
releasing the DIN rail latch or removing the four
mounting screws.
5. Install new module by snapping on to DIN rail or using
mounting screws.
6. Install terminal plugs (with wires).
7. Ensure the position of the four switches are the same as
the old module.
8. Retighten all wiring on the terminal plugs.
9. Apply power to the S3C Valve Module. Note: Ud
followed by dashes may appear on the display
while the module is updating.
19.20.3 DISPLAY MODULE
1. Remove the power and communications terminal plug
from the back of the display.
2. Press the slide locks and remove from the sides of the
display.
3. Slip out display from the panel/bulkhead.
4. Slide new display into bulkhead.
5. Install slide locks onto the display and compress against
bulkhead to ensure proper sealing.
6. Connect power and communications terminal plug.
Note: Ud followed by dashes may appear on
the display while the Display Module (DM) is
updating.
19.21 VIEWING CASE CONTROL FIRMWARE
REVISION
To view the controller rmware revision:
1. From the default display, press the  button. The
display will show   .
2. Use the ▲▼ buttons to enter the administrator
password and press SET.
3. The display will show (will skip to Process Values if
system is self-contained).
4. Press the SET button and  (Process Values) will be
displayed.
5. Press the SET button and  will be displayed.
6. Press the ▼ button until  (Version) is showing.
7. Press the SET button to display the Case Control
firmware revision.
8. Press the ESC button four times to exit the menu and
return to the default display.
19.22 FIRMWARE UPDATES
To update rmware, contact Sporlan Technical Support.
E-mail: svdtechsupport@parker.com
Phone: 636-392-3906