Elevators
The P350 elevators are used to elevate the camera and help center it in pipes 254mm (10”) in diameter or larger.
The P350 system offers a choice of elevators:
• Fixed elevator. The fixed elevator will deploy the P354 in pipes up to 300mm (12") and the P356 in pipes up to
380mm (15”).
• Adjustable elevator. The adjustable elevator will deploy the P354 in pipes up to 350mm (15") and the P356 in pipes
up to 458mm (18").
• Large adjustable elevator (For the P356 only).The large adjustable elevator will deploy the P356 in pipes from 300mm
(12”) up to 610mm (24").
• P356 powered elevator. To deploy the P356 in pipes from 305mm to 900mm (12 to 36"). This elevator can be remotely
controlled from the command module
Figure 2.8: P350 camera elevators
Adjustable elevator
To adjust the Adjustable elevator: Vent Screw
1. Loosen the Allen-head and the vent screws
2. Set the camera mount to the desired height.
3. Tighten the Allen-head and the vent screws to secure the elevator.
Allen-head screw
Large adjustable elevator
To fit the large adjustable elevator to the P356 crawler,
Align the four mounting holes and secure it using the
four screws provided. This is demonstrated in
Figure 2.11.
To adjust the elevator twist the square- recessed socket,
the supplied chuck key varies the height as required.
This is demonstrated in Figure 2.10.
Figure 2.10: Adjusting the large adjustable elevator
To Next Page
Loading...