PRUNING SHEARS C45, C45-P150, C45-P200
163529-D
3. When the tool is not in use, always switch off the battery (both LEDs on the tool should be off).
4. Do not leave the tool in the ground or exposed to the weather.
5. Make sure that the blade is not in contact with any object before starting the tool.
6. Never use the tool if it is damaged, incorrectly set or incompletely assembled.
7. Never remove or disable a safety device. Have the safety device repaired if is faulty.
8. Never disconnect the power cord from the tool without checking that the red and green LEDs on the left and
right of the battery display are off.
9. Never carry the tool by the power cord.
10. Do not disassemble the tool.
11. Do not try to cut pieces of wood that are too large or other materials than wood.
12. Please test the tool before use to check that it is working properly.
13. When using the tool at ground level, ensure that no persons or objects are in contact with the cutting device.
2.5. SAFETY SIGNS
California State Proposition 65:
Caution
This product contains or emits a chemical recognized by the State of California to cause cancer,
birth defects or other reproductive harm.
2.5.1. SAFETY SIGNS FOR THE C45
Do not expose to rain.
Please read the operating instruc-
tions.
Regulatory Compliance Mark
(RCM).
The product complies with the reg-
ulatory requirements of Australia
and New Zealand for electrical
safety, electromagnetic compati-
bility, radio frequency.
Tool compliant with Moroccan
standards.
10
To Next Page
Loading...
