PRUNING SHEARS C45, C45-P150, C45-P200
163529-D
Frequency of operations
Operations
Each time
the tool
is used
1
Every 4
hours
Every week After use
Have the tool checked by an authorised distibutor
PELLENC.
Important
Have your machine serviced every 200 hours
or at least once a year by a authorised distrib-
utor PELLENC. Always store the tool clean
and in a dry place, with the battery charged.
Battery Please refer to the battery operating instructions.
6.2. MAINTENANCE ADVICE
If the cut is no longer clean and effortless, this means that the tool is consuming more energy than necessary.
Then check:
1. blade sharpening,
2. the tightness of the blade,
3. greasing of the blade pin,
4. general condition of the tool.
The operating time and service life of the pruning shears mainly depend keeping the blade properly sharpened
and tightened.
6.3. CHECK
6.3.1. VISUAL CHECK OF THE GENERAL CONDITION OF THE TOOL
• Visually check the general condition of the tool.
32
To Next Page
Loading...
