pellenc C45 - Authorisation Modes

PRUNING SHEARS C45, C45-P150, C45-P200
163529-D
5.6.2. AUTHORISATION MODES
5.6.2.1.PRESENTATIONOFAUTHORISATIONMODES
It is possible to set the tool's setting level according to the tool's operating modes.
See 5.6.1. Usage modes, page 26.
• L1: “Normal" mode: the user has access to the 4 operating modes C1 to C4 but without any possibility of adjust-
ments.
• L2: "Expert" mode: the user has access to the 4 operating modes C1 to C4 and four settings F5 to F8 (factory
setting ).
To change the authorisation settings of the tool, see 5.6.2.3. Change of authorisation mode, page 29.
5.6.2.2.COMPATIBILITYBETWEENAUTHORISATIONMODESANDTOOLSETTINGS
Pruning shears C45 Setting mode
Pruning shears modes L1 L2
C1 : Progressive half opening
C2 : Progressive
C3 : All-or-nothing operation with half-opening
C4 : All-or-nothing
F5 : Blade crossing setting
F6 : Adjusting the half-opening
F7 : Adjusting optical sensor sensitivity
F8 : Tool standby delay setting
28