pellenc C45 - Page 4

PRUNING SHEARS C45, C45-P150, C45-P200
163529-D
5.2.1. STARTING THE TOOL ALONE WITH ACTIV' SECURITY ACTIVATED .............................................. 19
5.2.2. STARTING THE TOOL WITH A POLE WITH ACTIV' SECURITY ACTIVATED (FACTORY SET-
TING) ........................................................................................................................................................ 20
5.3. ACTIV'SECURITY DEACTIVATED ............................................................................................... 20
5.3.1. DEACTIVATING ACTIV' SECURITY ................................................................................................. 21
5.3.2. STARTING THE TOOL WITH ACTIV' SECURITY DEACTIVATED ...................................................... 22
5.3.3. ACTIVATING ACTIV' SECURITY ...................................................................................................... 22
5.4. BLADE OPENINGS ....................................................................................................................... 23
5.4.1. FULL OPENING OF THE BLADE ..................................................................................................... 23
5.4.2. OPTICAL SENSOR AND HALF-OPENING ........................................................................................ 24
5.5. SWITCHING TO AND FROM STANDBY ...................................................................................... 25
5.5.1. AUTOMATIC STANDBY MODE ........................................................................................................ 25
5.5.2. MANUAL STANDBY MODE ............................................................................................................. 25
5.5.3. EXITING STANDBY ......................................................................................................................... 25
5.6. HMI (HUMAN MACHINE INTERFACE) SETTINGS OF THE TOOL ............................................ 25
5.6.1. USAGE MODES .............................................................................................................................. 26
5.6.2. AUTHORISATION MODES ............................................................................................................... 28
5.6.3. "FUNCTIONAL" SETTING MODES ................................................................................................... 29
6. MAINTENANCE .................................................................................................................... 31
6.1. FREQUENCY OF OPERATIONS .................................................................................................. 31
6.2. MAINTENANCE ADVICE ............................................................................................................... 32
6.3. CHECK ........................................................................................................................................... 32
6.3.1. VISUAL CHECK OF THE GENERAL CONDITION OF THE TOOL ..................................................... 32
6.3.2. CHECKING THE OPERATION OF THE ACTIV'SECURITY AND THE CONDUCTIVITY OF THE
GLOVES ................................................................................................................................................... 33
6.3.3. CHECKING THE OPERATING TRIGGER ......................................................................................... 34
6.3.4. CHECKING THE CROSSING OVER OF THE HOOK AND THE BLADE ............................................. 35
6.3.5. SHARPENING THE BLADE ............................................................................................................. 37
6.3.6. ADJUSTING THE TIGHTNESS OF THE BLADE ............................................................................... 38
6.4. CHANGING THE BLADE OR PINS .............................................................................................. 38
6.4.1. REMOVE / FIT THE BLADE AND PINS OF THE TOOL ALONE ......................................................... 38
6.4.2. REMOVE / FIT THE BLADE AND PINS OF THE TOOL EQUIPPED WITH A P150 OR P200 POLE ....... 40
6.5. GREASING THE BLADE ............................................................................................................... 41
6.6. CLEANING THE TOOL .................................................................................................................. 41
7. INCIDENTS AND TROUBLESHOOTING ............................................................................. 42
7.1. TABLE OF INCIDENTS AND BREAKDOWNS ............................................................................. 42
7.2. ACTIV' SECURITY LED CODES SUMMARY ............................................................................... 43
7.3. SUMMARY OF BATTERY LED CODES ON C45 PRUNING SHEARS ....................................... 43
8. STORAGE AND TRANSPORT ............................................................................................ 44
8.1. STORAGE ...................................................................................................................................... 44
8.1.1. TOOL STORAGE ............................................................................................................................. 44
8.1.2. STORAGE OF THE TOOL WITH A P150 OR P200 POLE ................................................................. 44
9. ACCESSORIES AND CONSUMABLES .............................................................................. 45
9.1. INCLUDED ACCESSORIES .......................................................................................................... 45
9.2. OPTIONAL ACCESSORIES .......................................................................................................... 45
4