Installer Manual Magnum 742-762 - Programming
46 / 106 Ref. MKT-IM-012 / C - 25.10.2019
9. "PM"
Indicates that the time displayed is between 12:00 noon and 12:00
midnight.
"PM" indicator is not used if the clock mode is set to 24-hour (there is
no AM indicator).
10. "MIN"
Indicates that the value entered/displayed is in minute increments.
11. "g/L"
Indicates that the value entered/displayed is in grams/Liter.
12. "KG"
Indicates that the value entered/displayed is in kilograms or kilograins.
13. "x100"
x100 multiplier for large values.
14. "Lbs/ft
3
"
Indicates that the value entered/displayed for regenerant amount is in
pounds per cubic foot.
15. Faucet
Appears when the current flow rate is displayed.
The controller may show the faucet and "0", indicating no flow.
16. Maintenance interval
Displayed when the month in service exceed the value programmed in
parameter P11.
17. Digits
Four digits used to display the time, program value or error codes.
18. Number
Used with #19, #20 and #21.
Displays a sequence number or value.
19. History values (H)
The number displayed by #18 identifies which history value is currently
displayed.
20. Parameter (P)
Displayed only in advanced programming.
The number displayed by #18 identifies which parameter is currently
displayed.
21. Cycle (C)
The number displayed by #18 is the current cycle in the regeneration
sequence.
22. Hardness
Hardness setting - only used with 760 and 762 controllers.
23. Capacity
Shows estimated system capacity.
24. "x2"
Indicates a second regeneration has been called for.
25. Recycle sign
Flashes when a regeneration at the next time of regeneration has been
called for.
Also displayed (continuously) when in regeneration.
26. Salt
Programming the amount of regenerant.
If the controller is on a 3-cycle filter then the backwash time is
displayed.
27. Regeneration time and
day
Programming the time of regeneration and the days of regeneration.
28. Time and day
Programming the current time and day.
To Next Page
Loading...
