Pentair Riversoft - Operation; Operation Display; Regeneration Display; Manual Regeneration Procedures

Installer Manual Riversoft - Description
18 / 90 Ref. MKT-IM-045 / A - 13.03.2020
Valve configuration
Injector.................................................... E .......................G .......................F ....................... H
DLFC ....................................................... 6 gpm................8 gpm ...............7 gpm ............... 9 gpm
BLFC ....................................................... 0.14 gpm...........0.14 gpm ..........0.14 gpm .......... 0.14 gpm
Cycles duration [min]
Estimated water consumption per regeneration [L]
Softener connections
Inlet/Outlet.............................................. ¾" BSPT, male
Drain line ................................................ ½"
Overflow drain line ................................. ½"
Electrical
Controller Operating Voltage ................. 12 VAC (requires use of Pentair Water supplied transformer)
Input Supply Frequency.......................... 50 or 60 Hz
Motor Input Voltage ................................ 12 VAC
Controller Power Consumption ............. 6 W average
Protection rating..................................... IP23
Transient overvoltages........................... within the limits of category II
Pollution Degree..................................... 3
Temporary overvoltages must be limited in duration and in frequency.
Riversoft 4 Riversoft 8 Riversoft 15 Riversoft 30
C1 1 1 1 1 1 1 3 3 3 3 3 3
C2 27 28 30 29 31 34 52 56 63 59 66 81
C3 3 3 3 3 3 3 3 3 3 3 3 3
C4 1 1 1 1 1 1 3 3 3 3 3 3
C5 1 1 1 1 1 1 1 1 1 1 1 1
C6 1 1 1 1 1 1 1 1 1 1 1 1
C7 1.7 2.5 4.1 3.4 5 8.3 54.8 58.5 65.6 12.5 18.8 31.2
Riversoft 4 Riversoft 8 Riversoft 15 Riversoft 30
24.6 25.5 27.4 36.1 38.0 41.3 54.8 58.5 65.6 104.5 113.1 131.0