Pentax Optio I-10 - Changing the Start-Up Screen

209
7
Settings
4 Use the four-way controller
(45) to choose the image for
the subscreen.
Only images suitable for the
subscreen are displayed. You can
also choose one of the 3 pre-installed
screens already stored in the camera.
5 Press the 4 button.
The subscreen image is set.
You can choose the start-up screen displayed when the camera is
turned on.
You can choose any of the following images as the start-up screen:
- The Guide Display Start-up Screen showing a guide to the shooting
modes and buttons
- One of the 3 pre-installed screens
- One of your own images (compatible images only)
1 In Q mode, press the four-way controller (3).
The Playback Mode Palette appears.
2 Use the four-way controller
(2345) to select ^ (Start-
up Screen).
3 Press the 4 button.
The image selection screen appears.
• Once the subscreen image has been set, it will not be deleted even if
the original image is deleted or the SD Memory Card is formatted.
Changing the Start-up Screen
100-0017
100-0017
100-0017
OK
OK
OK
OK
OK
OK
MENU
MENU
Cancel
Cancel
MENU
Cancel
Start-up Screen
For setting a captured
image as the Start-up
Screen
OK
OK
MENU
Cancel
2/2