EasyManuals Logo

Pentax Optio I-10 User Manual

Pentax Optio I-10
271 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #212 background imageLoading...
Page #212 background image
210
7
Settings
4
Use the four-way controller
(45) to choose the image for
the start-up screen.
Only images suitable for the start-up
screen are displayed. You can also
choose one of the 3 pre-installed
screens or the Guide Display Start-up
Screen already stored in the camera.
5
Press the 4 button.
The start-up screen is set.
Pixel Mapping is a function for mapping out and correcting defective
pixels in the CCD sensor. Run the Pixel Mapping function if image dots
always seem to be defective in the same place.
1
Press the 3 button in A mode, and press the four-
way controller (5).
The [W Setting] menu appears.
[Pixel Mapping] cannot be selected when the 3 button is pressed
in Q mode.
2
Use the four-way controller (23) to select [Pixel
Mapping].
Once the start-up screen has been set, it will not be deleted even if the
original image is deleted or the SD Memory Card is formatted.
Select [Off] to hide the start-up screen.
The start-up screen is not displayed when the camera starts up in the
playback mode.
Correcting Defective Pixels in the CCD Sensor
(Pixel Mapping)
100-0017
100-0017
100-0017
OK
OK
OK
OK
OK
OK
MENU
MENU
Cancel
Cancel
MENU
Cancel

Table of Contents

Other manuals for Pentax Optio I-10

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Pentax Optio I-10 and is the answer not in the manual?

Pentax Optio I-10 Specifications

General IconGeneral
BrandPentax
ModelOptio I-10
CategoryDigital Camera
LanguageEnglish

Related product manuals