Pentax Optio I-10 - Using the Digital Wide Function (Digital Wide Mode)

94
3
Taking Pictures
4 Press the shutter release button on the remote control
unit.
When i (3-sec Remote Control) is selected: The focus frame turns
green at the point where the focus is achieved and the camera takes
a picture after about three seconds.
When h (0-sec Remote Control) is selected: The camera takes a
picture immediately.
In X (Digital Wide) mode, you can stitch two vertical images captured
with this camera into a single frame up to approx. 21 mm coverage (35
mm film equivalent).
• The operating range is approx. 4 m (13 ft) from the front of the camera
when using the remote control unit.
•In C (Movie) mode, pressing the shutter release button again stops
the recording.
• The camera takes a picture even if the focus is not achieved.
• In Remote Control mode, the self-timer lamp blinks. When the camera
receives a shutter release signal, the self-timer lamp blinks quickly
right before and after the shot takes place. Also, when the camera
receives a zoom signal, the self-timer lamp blinks quickly.
• If the shutter release button is pressed halfway during the countdown,
the countdown stops. If the shutter release button is pressed fully, the
camera starts the countdown again.
• i/hcannot be selected in 9 (Green) mode.
Using the Digital Wide Function
(Digital Wide Mode)
+