Pentax Optio I-10 - Resetting to Default Settings (Reset)

211
7
Settings
3 Press the four-way controller
(5).
The [Pixel Mapping] screen appears.
4 Use the four-way controller
(23) to select [Pixel
Mapping].
5 Press the 4 button.
Defective pixels are mapped and corrected.
You can reset the camera settings to their defaults. Refer to “Default
Settings” (p.246) for the reset settings.
1 Press the 3 button in Q mode.
The [W Setting] menu appears.
When you press the 3 button in A mode, press the four-way
controller (5) once.
2 Use the four-way controller (23) to select [Reset].
3 Press the four-way controller (5).
The [Reset] screen appears.
When the battery level is low, [Not enough battery power remaining to
activate Pixel Mapping] is displayed on the monitor. Use the AC adapter
kit K-AC92 (optional) or load a charged battery.
Resetting to Default Settings (Reset)
Setting
3/3
MENU
Exit
Delete All
Format
Pixel Mapping
Reset
OK
OK
Pixel Mapping
Checks the image sensor
and corrects defective
pixels
Pixel Mapping
Cancel