EasyManua.ls Logo

peplink ONE One - Page 125

peplink ONE One
249 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
NATMappingSettings
LAN
Client(s)
NATMappingrulescanbedefinedforasingleLANIPAddress,anIPRange,oranIP
Network.
Address
ThisreferstotheLANhost’sprivateIPaddress.Thesystemmapsthisaddresstoa
numberofpublicIPaddresses(specifiedbelow)inordertofacilitateinboundand
outboundtraffic.ThisoptionisonlyavailablewhenIPAddressisselected.
Range
TheIPrangeisacontiguousgroupofprivateIPaddressesusedbytheLANhost.The
systemmapstheseaddressestoanumberofpublicIPaddresses(specifiedbelow)to
facilitateoutboundtraffic.ThisoptionisonlyavailablewhenIPRangeisselected.
Network
TheIPnetworkreferstoallprivateIPaddressesandrangesmanagedbytheLANhost.
ThesystemmapstheseaddressestoanumberofpublicIPaddresses(specifiedbelow)
tofacilitateoutboundtraffic.ThisoptionisonlyavailablewhenIPNetworkisselected.
Inbound
Mappings
ThissettingspecifiestheWANconnectionsandcorrespondingWANspecificInternetIP
addressesonwhichthesystemshouldbind.AnyaccesstothespecifiedWAN
connection(s)andIPaddress(es)willbeforwardedtotheLANhost.Thisoptionisonly
availablewhenIPAddressisselectedintheLANClient(s)field.
Note1:InboundmappingisnotneededforWANconnectionsindropinmodeorIP
forwardingmode.
Note2:EachWANIPaddresscanbeassociatedtooneNATmappingonly.
Outbound
Mappings
ThissettingspecifiestheWANIPaddressesshouldbeusedwhenanIPconnectionis
madefromaLANhosttotheInternet.
EachLANhostinanIPrangeorIPnetworkwillbeevenlymappedtooneofeach
selectedWAN'sIPaddresses(forbetterIPaddressutilization)inapersistentmanner(for
betterapplicationcompatibility).
Note1:IfyoudonotwanttouseaspecificWANforoutgoingaccesses,youshouldstill
choosedefaulthere,thencustomizetheoutboundaccessruleintheOutboundPolicy
section.
Note2:WANconnectionsindropinmodeorIPforwardingmodearenotshownhere.
ClickSavetosavethesettingswhenconfigurationhasbeencompleted.
ImportantNote
Inboundfirewallrulesoverrideinboundmappingsettings.
https://www.peplink.com
125
Copyright@2019Peplink

Table of Contents