peplink ONE One - Intrusion Detection and Dos Prevention


Tochangearule’spriority,simplydraganddroptherule:
● Holdtheleftmousebuttonontherule.
● Moveittothedesiredposition.
● Dropitbyreleasingthemousebutton.



Toremovearule,clickthe button.
Rulesarematchedfromtoptothebottom.Ifaconnectionmatchesanyoneoftheupperrules,the
matchingprocesswillstop.Ifnoneoftherulesmatchtheconnection,theDefaultrulewillbeapplied.
TheDefaultruleisAllowforbothoutboundandinboundaccess.
Tip
IfthedefaultinboundruleissettoAllowforNATenabledWANs,noinboundAllowfirewallruleswillberequired
forinboundportforwardingandinboundNATmappingrules.However,ifthedefaultinboundruleissetasDeny,
acorrespondingAllowfirewallrulewillberequired.

IntrusionDetectionandDoSPrevention

TheBalancecandetectandpreventintrusionsanddenialofservice(DoS)attacksfromtheInternet.To
turnonthisfeature,click ,checktheEnablecheckboxfortheIntrusionDetectionandDoS
Prevention,andpresstheSavebutton.
Whenthisfeatureisenabled,theBalancewilldetectandpreventthefollowingkindsofintrusionsand
denialofserviceattacks.
● Portscan
o NMAPFIN/URG/PSH
o Xmastree
o AnotherXmastree

https://www.peplink.com
149
Copyright@2019Peplink
