peplink ONE One - Grouped Networks 1


sessiontothesameWANconnectionandtranslateIPaddressintheSIPpackets
correctlyinNATmode.Suchpassthroughsupportisalwaysenabledandtherearetwo
modesforselection:StandardModeandCompatibilityMode.
IfyourSIPserver’ssignalportnumberisnonstandard,youcanchecktheboxDefine
customsignalportsandinputtheportnumberstothetextboxes.
H.323
Withthisoptionenabled,protocolsthatprovideaudiovisualcommunicationsessionswill
bedefinedonanypacketnetworkandpassthroughtheBalance.
FTP
FTPsessionsconsistoftwoTCPconnections;oneforcontrolandonefordata.Ina
multiWANsituation,theymustberoutedtothesameWANconnection.Otherwise,
problemswillariseintransferringfiles.Bydefault,thePeplinkBalancemonitorsTCP
controlconnectionsonport21foranyFTPconnectionsandbindsTCPconnectionsof
thesameFTPsessiontothesameWAN.
IfyouhaveanFTPserverlisteningonaportnumberotherthan21,youcancheck
Definecustomcontrolportsandentertheportnumbersinthetextboxes.
TFTP
ThePeplinkBalancemonitorsoutgoingTFTPconnectionsandroutesanyincoming
TFTPdatapacketsbacktotheclient.SelectEnableifyouwanttoenableTFTP
passthroughsupport.
IPsecNATT
ThisfieldisforenablingthesupportofIPsecNATTpassthrough.UDPports500,4500,
and10000aremonitoredbydefault.
YoumayaddmorecustomdataportsthatyourIPsecsystemusesbycheckingDefine
customports.IftheVPNcontainsIPsecsitetositeVPNtraffic,checkRouteIPsec
SitetoSiteVPNandchoosetheWANconnectiontoroutethetrafficto.










14.2.5 GroupedNetworks

Using“GroupedNetworks”youcangroupandnamearangeofIPaddresses,whichcanthenbeusedto
definefirewallrulesoroutboundpolicies.


https://www.peplink.com
167
Copyright@2019Peplink
