peplink ONE One - CLI (Command Line) Support 2



Thetestcanberunagainonceit’scompletebyclickingtheStartbuttonoryoucanclick
Closeandchangetheparametersforthetest.


16.7 CLI(CommandLine)Support
TheserialconsoleconnectoronsomePeplinkBalanceunitsisRJ45.Toaccessthe
serialconsoleport,prepareaRJ45toDB9consolecable.ConnecttheRJ45endto
theunit'sconsoleportandtheDB9endtoaterminal'sserialport.Theportsettingwill
be115200,8N1.

https://www.peplink.com
209
Copyright@2019Peplink
