peplink ONE One - Bandwidth Control


Twodefaultrulesarepredefinedandputatthebottom.TheyareAllDHCPreservation
clientsandEveryone,andtheycannotberemoved.TheAllDHCPreservationclientrepresentsthe
LANclientsdefinedintheDHCPReservationtableontheLANsettingspage.Everyonerepresentsall
clientsthatarenotdefinedinanyruleabove.Clickonaruletochangeitsgroup.

Add/EditUserGroup
Subnet/IP
Address
Fromthedropdownmenu,choosewhetheryouaregoingtodefinetheclient(s)by
anIPAddressoraSubnet.
IfIPAddressisselected,enteranamedefinedinDHCPreservationtableoraLAN
client'sIPaddress.IfSubnetisselected,enterasubnetaddressandspecifyitssubnet
mask.
Group
ThisfieldistodefinewhichUserGroupthespecifiedsubnet/IPaddressbelongsto.
Once users have been assigned to a user group, their internet traffic will be restricted by rules defined for                  
thatparticulargroup.Pleaserefertothefollowingtwosectionsfordetails.

12.10.2 BandwidthControl
ThissectionistodefinehowmuchminimumbandwidthwillbereservedtoeachusergroupwhenaWAN
connectionisinfullload.Whenthisfeatureisenabled,asliderwithtwoindicatorswillbeshown.You
canmovetheindicatorstoadjusteachgroup'sweighting.Thelowerpartofthetableshowsthe
correspondingreserveddownloadanduploadsbandwidthvalueofeachconnection.
Bydefault,50%ofbandwidthhasbeenreservedforManager,30%forStaff,and20%forGuest.

Youcandefineamaximumdownloadspeed(overallWANconnections)anduploadspeed(foreach
WANconnection)thateachindividualStaffandGuestmembercanconsume.Nolimitcanbeimposedon
individualManagers.Bydefault,downloadanduploadbandwidthlimitsaresettounlimited(setas0).

https://www.peplink.com
142
Copyright@2019Peplink
