peplink ONE One - Page 220


TheavailabledetailsareWANName,IPaddressandportusedfortheSpeedfusionconnection.Rxand
Txrates,LossrateandLatency.
ConnectionscanbetemporarilydisabledbyslidingtheswitchbuttonnexttoaWANconnectiontotheleft.
Thewantowanconnectiondisabledbytheswitchistemporaryandwillbereenabledafter15minutes
withoutanyaction.
ThiscanbeusedwhentestingthePepVPNspeedbetweentwolocationstoseeifthereisinterferenceor
networkcongestionbetweencertainWANconnections.

ThePepVPNtestconfigurationallowstoconfigureandperformthroughputtests.
THisisusuallydoneaftertheinitialinstallationoftheroutersandincasethereareproblemswith
aggregation.

PresstheStartbuttontoperformthroughputtestaccordingtotheconfiguredoptions.

IfTCPisselected,4parallelstreamswillbegeneratedtogettheoptimalresultsby
default.Thiscanbecustomizedbyselectingadifferentvalueofstreams.
Usingmorestreamswilltypicallygetbetterresultsifthelatencyofthetunnelishigh.


https://www.peplink.com
220
Copyright@2019Peplink
