peplink ONE One - Page 61


BandSelection
WhensettoAuto,bandselectionallowsforautomaticallyconnectingtoavailable,supported
bands(frequencies).
WhensettoManual,youcanmanuallyselectthebands(frequencies)theSIMwillconnectto.
DataRoaming
ThischeckboxenablesdataroamingonthisparticularSIMcard.Whendataroamingis
enabledthisoptionallowsyoutoselectinwhichcountriestheSIMhasadataconnection.
TheoptionisconfiguredbyusingMMC(country)codes.Pleasecheckyourserviceprovider’s
dataroamingpolicybeforeproceeding.
Authentication
ChoosefromPAPOnlyorCHAPOnlytousethoseauthenticationmethodsexclusively.
SelectAutotoautomaticallychooseanauthenticationmethod.
Operator
Settings
ThissettingallowsyoutoconfiguretheAPNsettingsofyourconnection.IfAutoisselected,
themobileoperatorshouldbedetectedautomatically.Theconnecteddevicewillbe
configuredandconnectionwillbemadeautomatically.Ifthereisanydifficultyinmaking
connections,youmayselectCustomtoenteryourcarrier’sAPN,Login,Password,and
DialNumbersettingsmanually.Thecorrectvaluescanbeobtainedfromyourcarrier.The
defaultandrecommendedsettingisAuto.
APN/Login/
Password/
SIMPIN
WhenAutoisselected,theinformationinthesefieldswillbefilledautomatically.Select
Customtocustomizetheseparameters.Theparametervaluesaredeterminedbyandcan
beobtainedfromtheISP.
Bandwidth
Allowance
Monitor
ChecktheboxEnabletoenablebandwidthusagemonitoringonthisWANconnectionfor
eachbillingcycle.Whenthisoptionisnotenabled,bandwidthusageofeachmonthisstill
beingtrackedbutnoactionwillbetaken.
Action
Ifemailnotificationisenabled,youwillbenotifiedbyemailwhenusagehits75%and95%of
themonthlyallowance.IfDisconnectwhenusagehits100%ofmonthlyallowanceis
checked,thisWANconnectionwillbedisconnectedautomaticallywhentheusagehitsthe
monthlyallowance.Itwillnotresumeconnectionunlessthisoptionhasbeenturnedofforthe
usagehasbeenresetwhenanewbillingcyclestarts.
StartDay
Thisoptionallowsyoutodefinewhichdayofthemontheachbillingcyclebegins.
Monthly
Allowance
ThisfieldisfordefiningthemaximumbandwidthusageallowedfortheWANconnectioneach
month.









https://www.peplink.com
61
Copyright@2019Peplink
