This represents the LAN interfaces that are active on your router (including VLAN). A grey “X”
means that the VLAN is used in other settings and cannot be deleted. You can find which
settings are using the VLAN by hovering over the grey “X”.
Alternatively, a red “X” means that there are no settings using the VLAN. You can delete that
VLAN by clicking the red “X”
Clicking any of the existing LAN interfaces (or creating a new one) will result in the following
The IP address and subnet mask of the Pepwave router on the LAN.
Enter a name for the LAN.
Enter a number for your VLAN.
Check this box to enable routing between virtual LANs.
To Next Page
Loading...
