This is the number of consecutive check failures before treating a connection as down.
This is the number of responses required after a health check failure before treating a
connection as up again.
Bandwidth Allowance Monitor Settings
Bandwidth
Allowance
Monitor
Check the box Enable
to enable bandwidth usage monitoring on this WAN connection for
each billing cycle. When this option is not enabled, bandwidth usage of each month is still
being tracked but no action will be taken.
If Email Notification is enabled, you will receive an email notification when usage hits 75%
and 95% of the monthly allowance.
If the box Disconnect when usage hits 100% of monthly allowance is checked, this WAN
connection will be disconnected automatically when the usage hits the monthly allowance. It
will not resume unless this option has been turned off or the usage has been reset when a
new billing cycle starts.
This option allows you to select which day of the month a billing cycle starts.
This field is to specify the bandwidth allowance for each billing cycle.
To Next Page
Loading...
