Preferred SIM
Card
If “Both SIMs” were selected on the above field, then you can designate the priority of
the SIM card slots here.
Remote SIM
Settings
You may need to enable the remote SIM Host settings in the Remote SIM
management, see the section 22.10 or Appendix B for more details on FusionSIM.
After that, click on “Scan nearby remote SIM server” to show the serial number(s)
of the connected SIM Injector(s).
If you want to select a specific SIM, in the Cellular Settings, type “:” and then the
number of the SIM slot, eg.1111-2222-3333:7.
LTE/3G
Optimal
Network
Discovery
Cellular WANs by default will only handover from 3G to LTE network when there is no
active data traffic, enable this option will make it run the handover procedures after
fallback to 3G for a defined effec
tive period, even this may interrupt the connectivity
for a short while.
Band Selection
When set to Auto,
band selection allows for automatically connecting to available,
supported bands (frequencies) .
When set to Manual, you can manually select the bands (frequencies) the SIM will
connect to.
Data Roaming
This checkbox enables data roaming on this particula
r SIM card. When data roaming
is enabled this option allows you to select in which countries the SIM has a data
connection. The option is configured by using MMC (country) codes.Please check your
service provider’s data roaming policy before proceeding.
Authentication
Choose from PAP Only or CHAP Only
to use those authentication methods
exclusively. Select Auto to automatically choose an authentication method.
Operator
Settings
This setting allows you to configure the APN settings of your connection. If Auto
selected, the mobile operator should be detected automatically. The connected device
will be configured and connection will be made automatically. If there is any difficulty
To Next Page
Loading...
Need help?
General
