in making connection, you may select Custom to enter your carrier’s APN, Login,
Password, and Dial Number
settings manually. The correct values can be obtained
from your carrier. The default and recommended setting is Auto.
Password /
SIM PIN
When Auto is selected, the information in these fields will be filled automatically. Select
Custom to customize these parameters. The parameter values are determined by and
can be obtained from the ISP.
Bandwidth
Allowance
Monitor
Check the box Enable to enable bandwidth usage monitoring on this WAN connection
for each billing cycle. When this option is not enabled, bandwidth usage of each month
is still being tracked but no action will be taken.
Action
If email notification
is enabled, you will be notified by email when usage hits 75% and
95% of the monthly allowance. If Disconnect when usage hits 100% o
allowance
is checked, this WAN connection will be disconnected automatically when
the usage hits the monthly allowance. It will not resume connection unless this option
has been turned off or the usage has been reset when a new billing cycle starts.
Start Day
This option allows you to define which day of the month each billing cycle begins.
Monthly
Allowance
This field is for defining the maximum bandwidth usage allowed for the WAN
connection each month.
Signal Threshold Settings
If signal threshold is defined, this connection will be treated as down when a weaker than
threshold signal is determined.
The following values are used by the threshold scale:
To define the threshold manually using specific signal strength values, please click on the
question Mark and the following field will be visible.
To Next Page
Loading...
Need help?
General
