Health Check Settings
Health Check
Method
This setting allows you to specify the health check method for the cellular connection.
Available options are Disabled, Ping, DNS Lookup, HTTP, and SmartCheck
default method is DNS Lookup. See Section 10.4 for configuration details.
Timeout
If a health check test cannot be completed within the specified amount of time, the test
will be treated as failed.
Health Check
Interval
This is the time interval between each health check test.
Health Check
Retries
This is the number of consecutive check failures before treating a connection as down.
Recovery
Retries
This is the number of responses required after a health check failure before treating a
connection as up again.
Dynamic DNS Settings
Dynamic DNS
Service
Provider
This setting specifies the dynamic DNS service provider to be used for the WAN based
on supported dynamic DNS service providers:
● changeip.com
● dyndns.org
● no-ip.org
To Next Page
Loading...
Need help?
General
