Need help?Do you have a question about the Peri SKYDECK and is the answer not in the manual?
General| Drophead | Yes, allows early striking and reuse of panels. |
|---|---|
| Platform Height | N/A - SKYDECK is a formwork system, not a platform. |
| Platform Length | N/A - SKYDECK is a formwork system, not a platform. |
| Power Source | N/A - SKYDECK is manually assembled. |
| Drive Speed | N/A - SKYDECK is manually assembled. |
| Gradeability | N/A - SKYDECK is a formwork system, not a mobile machine. |
| Turning Radius | N/A - SKYDECK is a formwork system, not a mobile machine. |
| Outrigger Width | N/A - SKYDECK does not utilize outriggers. |
Identifies the primary elements of the SKYDECK system.
Explains symbols and conventions used in the manual.
Clarifies that illustrations are representative and may not show all variations.
Specifies the intended users and their roles.
Lists other relevant PERI publications for SKYDECK.
Defines the system's application for slab formwork up to 109 cm.
Provides guidance on cleaning, repair, and upkeep of formwork.
Outlines general principles for correct system operation.
Covers general safety aspects applicable across different systems.
Addresses safety precautions specific to the SKYDECK system.
Details safe procedures for handling and storing components.
Explains the basis for design calculations and load assumptions.
Presents data on permissible internal forces for structural elements.
Defines vertical and horizontal loads for design calculations.
Details the initial setup steps for forming the first bay.
Explains the procedure for shuttering bays oriented transversely.
Outlines the method for shuttering bays oriented longitudinally.
Describes the standard assembly sequence for typical bays.
Lists components used for creating compensations and column shuttering.
Explains the use of triangular frames for infill areas with inclined walls.
Details how to form longitudinal gaps and compensations.
Describes the process for forming transverse infills and compensations.
Covers shuttering for single-column openings.
Details shuttering procedures for double-column openings.
Explains shuttering for triple-column openings.
Describes shuttering for main beams that are recessed.
Provides instructions on how to adjust the main beam position.
Explains how horizontal loads are transferred to building columns.
Covers general principles for bracing formwork structures.
Details how to brace internal bays longitudinally and horizontally.
Analyzes load transfer from a casting segment to bracing elements.
Addresses bracing requirements to prevent tipping on open edges.
Explains how to form cantilevers using Panels SDP.
Describes forming cantilevers using SKYDECK platforms.
Details the assembly and use of handrail units for safety.
Explains the installation of guardrail holders and posts.
Provides a general introduction to the SKYDECK platform system.
Outlines the assembly of the corner table structure.
Details the process for forming cantilevers with SKYDECK platforms.
Describes shuttering procedures for open edge areas.
Explains the standard method for forming the main slab area.
Covers the procedure for closing off infill areas.
Provides step-by-step instructions for installing SKYDECK platforms.
Details the procedure for dismantling the SKYDECK platforms.
Explains the use of platforms as working and safety scaffolds.
Describes how to change direction using Prophead SSK.
Explains changing direction with Drophead SFK.
Details bracing methods for inclined slabs using specific components.
Explains bracing techniques for inclined slabs using the Tension Unit SD.
Lists maximum slab inclinations and corresponding loads.
Provides load data for inclined slabs using Drophead SFK.
Offers load data for inclined slabs using Prophead SSK.
Details prop loads for the panel system.
Provides guidance on striking times based on concrete strength.
To Next Page
