Peri SKYDECK - Default Chapter; Table of Contents

SKYDECK Panel Slab Formwork
Instructions for Assembly and Use – Standard Configuration
Content
Overview
Main components 1
Key 2
Presentational reference 2
Introduction
Target groups 3
Additional technical documentation 3
Intended use 4
Care and maintenance instructions 5
Instructions for Use 5
Safety instructions
Cross-system 6
System-specific 7
Storage and transportation 7
Standard configuration
A1 Storage and transportation 8
A2 System components 11
A3 System dimensions 14
Notes regarding static calculations 14
Internal forces and rigidity 15
Load combinations 15
A4 Shuttering 17
Starting bay 17
Transverse bay 19
Longitudinal bay 20
Standard bay 21
A5 Compensations 24
System components 24
Edge Beam SRT 150, SRT 75 24
Filler Timber SPH 24
End Support SSL 24
Combihead SCK 25
Triangular Frame SDR 150/75, 75/75 28
Longitudinal compensations 28
Transverse compensations 31
A6 Shuttering around columns 34
1 recessed panel 34
2 recessed panels 35
3 recessed panels 36
Recessed main beams 37
Shifting the main beam axis 37
A7 Horizontal bracing 38
Transfer of horizontal loads into the
columns of the building 38
General 39
Bracing of the inner bay 39
Transfer of horizontal loads from a
casting segment 40
A8 Cantilevers, Guardrails 42
Bracing on leading edges to prevent
tipping 42
Guardrails with Handrail Unit SD 43
SKYDECK Guardrail Holder SGH and
Guardrail Post SGP 44
A9 SKYDECK platforms 46
Corner table (Area l) 47
Cantilevers (Area ll) 51
Open edge areas (Area lll) 52
Slab areas (Area lV) 52
Infill areas 52
Platform installation 53
Striking 54
Working and safety scaffold 55
A10 Changing direction 56
– System with Prophead SSK 56
– System with Drophead SFK 58
A11 Inclined slabs 60
Bracing with Tension Sleeve SAO and
Chain 3.0 kN 60
Bracing with Tension Unit SD 61
A12 Striking 62
A13 Site record 64
Design tables
A14 Horizontal loads with Slab Props PEP 65
A15 Inclined slabs 66
Maximum permissible slab inclination with
Tension Sleeve SAO and Chain 3.0 kN 66
Tension Unit SD – bracing angle 66
Tensile force of Tension Unit SD and
prop loads
– System with Drophead SFK 67
– System with Prophead SSK 70
A16 SKYDECK standard configuration 73
Prop loads
– System with Drophead SFK 73
– System with Prophead SSK 74
– Panel system 75
Striking guide values 75
A17 Filler plates, forming around columns 76
A18 Slab props 77
– PEP 20 77
– PEP 20 with Base MP 50 78
– PEP 30 79
– PEP 30 with Base MP 50 80
– PEP Ergo B 81
– PEP Ergo D 82
– PEP Ergo E 83
– MULTIPROP 250, 350, 480, 625 84
Components
Components
86
SKYDEKC AuV_ex_791458.indb 1 13.12.16 16:53