Adjustment
13 - 33
Message Description
E001 System error
E002: Sewing motor
E003: Section
E004: End of section
E005: Pedal activated when machine switched on
E006: Communication error with stepping
motor processor
E007: End of ramp
E008: End position of needle drive not found
E009: Centre position of needle drive not found
E010: Error of stepping motor processor
E011: Stepping motor stepping frequency too high
E012: Error in sewing start deflection
E013: Error in docu-seam system
E014: Incorrect program number (larger than 99)
E015: Incorrect section number
E016: Memory full
E017: Incorrect stitch length
E019: Interface to external controller
E021: Power supply unit overloaded
E022: Mains voltage
E023: Power supply 24V too high/too low
E024: Error at CAN interface
13.08 Warning messages
13
.07 Explanation of the error messages
Message Description
WARNING 2 Bobbin thread error
To Next Page
Loading...
