Adjustment
13 - 13
13.04.11 Automatic presser foot lift
Requirement
When solenoid 1 is activated, lever 3 should drop automatically to raise the roller presser.
● Adjust solenoid 1 ( screws 2 ) in accordance with the requirement.
● Switch on the machine and check the requirement.
● Switch off the machine.
Depending on the material thickness, the clearance between roller presser and
feed wheel can be increased up to 10 mm by moving the solenoid 1 to the
right.
1
2
Fig. 13 - 11
63-020
3
To Next Page
Loading...
