Pfaff 3834-14/11 - Mounting the Belt Guard of the Flange Motor

Mounting and commissioning the machine
8 - 6
77-014
8.02.05 Mounting the belt guard of the flange motor
● Attach belt guard 1 with screws 2 and 3.
Fig. 8 - 08
1
2
3
Fig. 8 - 07
77-012
4
5
7
7
6
● Move bearing plate 6 of the motor, so that toothed belt 5 is stretched.
● In this position tighten screws 7.
● Turn the balance wheel in sewing direction until the needle point descending from above,
is level with the top edge of the needle plate and re-check the value. A tolerance of
± 2 increments is allowed.
● Conclude the input.