Mounting and commissioning the machine
8 - 5
8
.02.04 Mounting the toothed belt / Basic position of the machine drive unit
● Switch on the machine.
● Call up the input mode.
● Select the service menu.
● Enter the code number, see Chapter 9.12 Entering/altering the code number.
● Turn the motor shaft by hand, until the value "11" is under "POS" on the display.
● Turn the balance wheel in sewing direction until the needle point descending from above,
is level with the top edge of the needle plate.
● Fit toothed belt 5, making sure that both motor shaft 4 (Fig. 8 - 07) and the machine are
not moved.
11
2.5 2.5
50
To Next Page
Loading...
