Input
11 - 10
11
.02.02 Example of a seam program input using the "Teach in" function
The seam program to be created should
- consist of a right and a left sleeve seam (beginning with the right)
- contain 2 seam sections
- be based on a basic size 50 (German men’s size)
- have a basic stitch length of 2.4 mm
- be stored under the program number "5" with the comment "LEARN".
● Switch on the machine.
● Select the program number "5", see Chapter 9.07 Selecting a program number.
● Call up the input mode.
● Call up the "Teach in" function.
● Set the basic size "50".
● Set the feed stroke "2.4" as the basic stitch length for the feed wheel.
● Set the seam type (right and left sleeve seam, beginning with right) by pressing the
appropriate symbol several times until the corresponding seam type appears.
● Call up the menu for comment input.
● Enter the comment with the keyboard and number panel.
● Conclude comment input.
● Change to input of the first seam section.
2.4
5
11
LERNEN
2.4
To Next Page
Loading...
