Input
11 - 4
11.01.02 Seam program input with the "Creating/adjusting a program" function
With this function the seam program is entered by entering or changing the appropriate
values on the control panel. This type of seam program input is particularly suitable for
adjusting existing seam programs.
● Switch on the machine.
● Select a program number from 3 – 49, see Chapter 9.07 Selecting a program number.
● Call up the input mode.
● Call up the "Creating/adjusting a seam program" function.
● Carry out the basic settings and conclude with the "Enter" function, see Chapter 11.01.01
Basic setting for seam program input.
● Set the feed stroke for the roller presser.
The difference to the feed stroke of the feed wheel (basic stitch length) determines the
fullness.
● Enter the basic value for the thread tension.
The actual value of the thread tension is composed of this basic value and ,if applicable,
the manual alteration in programmed sewing.
● Enter the length of the seam section.
The length of the seam section is given in "mm". When this seam section length has been
sewn, in programmed sewing the machine switches to the next seam section.
● Enter the graduated value.
The graduated value (in mm) is used to adapt different garment sizes to the programmed
basic size.
● Enter the start backtacks (function at beginning of seam) see Chapter 9.10 Entering the
start and end backtacks.
2.7
+50
124
3.0
+50
2.7
124
3.0
2.510
15
15
To Next Page
Loading...
