Care and Maintenance
12 - 1
These maintenance intervals are calculated for the average running time of a
single shift operation. If the machine is operated more than this, shorter
intervals are recommended.
12.01 Cleaning
Clean the hook, hook compartment and toothed wheel 3 daily, several times if in continuous use.
Switch the machine off!
Danger of injury if the machine
is started accidentally!
● Bring the needle bar to its highest position.
● Open the post cap and remove the bob-
bin case cap and the bobbin.
● Unscrew hook gib 1.
● Turn the handwheel until the point of
bobbin case 2 penetrates into the groove
of the hook race approx. 5 mm.
● Remove bobbin case 2.
● Clean the hook race with paraffin.
● When inserting the bobbin case 2,
ensure that the horn of the bobbin
case 2 engages in the groove of the
needle plate.
● Screw hook gib 1 back on and close the
post cap.
87-014
12 Care and Maintenance
Cleaning ..................................................... daily, several times if in continuous operation
Oiling the hook............................................................................... daily, before operation
Checking the oil levels ................................................................... daily, before operation
Lubricating the bevel gears ............................................................................. once a year
5 mm
1
2
Fig. 12 - 01
3
● Remove the puller cover and clean the
puller gears daily, several times if in
continuous operation.
To Next Page
Loading...
