Adjustment
13 - 30
13
.06.03 List of parameters
The operator has free access to the "100" parameters. Parameters "200" – "800"
can only be changed after entering a code number and many only be changed
by authorised personnel.
Group Parameter Description Setting Set
range value
1 101 Start backtack, pedal-controlled
(OFF = AUS, ON = EIN) OFF
102 Reversing
(OFF = AUS, ON = EIN) OFF
103 Stitch placement
(OFF = AUS, ON = EIN) OFF
104 Bobbin thread monitoring
(0 = OFF, 1 = reverse counter,
2 = thread monitor) 0 - 2 0
105 Bobbin thread reverse counter 0 -99999 12000
106 Remaining bobbin thread counter 0 -999 100
107 Maximum stitch length of fullness 0.8 - 6.5 4.0
pedal [mm]
108 Display software version of main
processor 0329/....
110 Display software version of the control panel V...H...
111 Software version of the sewing drive V35
112 Key tone of the control panel
OFF = Aus, ON = Ein ON
113 Beep tone for section change
OFF = Aus, ON = Ein ON
114 Display software version of the thread V..
strength module
2 201 Knee switch for section change
(in the seam programs 3-49)
OFF = Aus, ON = Ein OFF
202 Lowering speed roller presser
OFF = quick, ON = slow ON
203 Puller
OFF / ON OFF
3 301 Position take-up lever t.d.c. 0 - 127 2
To Next Page
Loading...
